NEC UX5000 - Basic Programming at the Receiving System

Networking (AMIS)
242 ◆ Chapter 2: Features UX Mail Manual
Basic Programming at the Receiving System
Step 1 Allow the receiving system to accept incoming network calls.
1.1 CUSTOMIZE: SYSTEM OPTIONS: [GENERAL 1]: INCOMING NETWORK CALL MODE (PAGE 459).
- Select All to allow the receiving system to accept all network calls.
- To set up the receiving system to accept network calls only from specific sites, see Setting
Up Network Site Restriction below.
✔ By default, this option is
None (receiving system will not accept network calls).