Customize
System Options: [Dial Strings]
UX Mail Manual Chapter 3: Programming ◆ 465
3
System Options: [Dial Strings]
Dial Strings Tab
[Dial Strings] RNA Hold Retrieval
Use this option to set the dial string voice mail uses to pick up an outside call from Hold. Voice mail will dial
this string if it places an Automated Attendant screened Transfer (TRF) and the destination extension does
not answer or is busy.
● See AUTOMATED ATTENDANT (PAGE 68) for more.
Options
● Digits (20 maximum, using 0-9, # and *)
● N (None)
● A (Analyzed pause)
This command waits for 4 seconds, and then continues if busy tone or reorder tone are not detected.
● F (Flash)
This command hook flashes the voice mail port, which places it on Hold.
- To set the duration of the Flash, go to
[TIMERS] FLASH TIMER (PAGE 474).
● M (Monitored pause)
This command waits for 2 seconds, and then continues if busy tone or reorder tone are not detected.
● P (Pause)
This command waits for 2 seconds and then continues.
● S (Wait for sound)
This command waits 2 seconds for any constant sound (such as non-standard dial tone), and continues
if sound is detected.
● W (Wait for dial tone)
This command waits for CO dial tone, and then continues.
Compatibility Guidelines:
■ When using the UX Mail Administrator to enter dial strings, take care not to enter illegal characters
(such as dashes). Enter only those characters allowed by the option you are programming.
This dial string is automatically set during installation. You
should not change this entry from its default setting.
To Next Page
Loading...
Need help?
General