Customize
Tenant Options: [General]
UX Mail Manual Chapter 3: Programming ◆ 477
3
[General] Site’s Network Telephone Number
Use this option when setting up Networking Site Restriction (page 237). The illustration below shows an
example of the related options in both the sending and receiving systems for a typical system installed in
North America.
1. In the sending system, enter the Site’s Network Telephone Number (using # delimiters as described in
Options below).
● Enter the number exactly as it should be dialed, excluding the leading 1 (if required) and trunk access
codes.
2. In the receiving system, enter this same number in the Network Mailbox and turn on Selected Incoming
Network Call Mode in System Options.
● In the number in the following Customize: Mailbox Options Edit: Network fields:
-
[NETWORK] NETWORK PREFIX NUMBER (PAGE 415).
-
[NETWORK] NETWORK COUNTRY CODE (PAGE 415).
-
[NETWORK] NETWORK AREA CODE (PAGE 415).
-
[NETWORK] NETWORK PHONE NUMBER (PAGE 416).
- The mailbox can be either a Network Remote Mailbox or a Network Alias Mailbox.
● Choose Selected in Customize: System Options: [GENERAL 1]: INCOMING NETWORK CALL MODE (PAGE 459).
To Next Page
Loading...
Need help?
General