Customize
System Options: [Dial Strings]
466 ◆ Chapter 3: Programming UX Mail Manual
● $ - Not used.
Default
✔ F*7 (Flash then dial *7)
[Dial Strings] Busy Hold Retrieval
This option is not used.
[Dial Strings] External RNA Hold Retrieval
Use this option to set up the RNA External Hold Retrieval String for the External Extension feature. If voice
mail routes an External Extension transfer and the called destination is unanswered, it dials this string to
retrieve the call. This string is normally
F
.
● See EXTERNAL EXTENSION (PAGE 137) for more.
Options
● Digits (20 maximum, using 0-9, # and *)
● N (None)
● A (Analyzed pause)
This command waits for 4 seconds, and then continues if busy tone or reorder tone are not detected.
● F (Flash)
This command hook flashes the voice mail port, which places it on Hold.
- To set the duration of the Flash, go to
[TIMERS] FLASH TIMER (PAGE 474).
● M (Monitored pause)
This command waits for 2 seconds, and then continues if busy tone or reorder tone are not detected.
● P (Pause)
This command waits for 2 seconds and then continues. You can enter a pause command anywhere in
the dial string.
● S (Wait for sound)
This command waits 2 seconds for any constant sound (such as non-standard dial tone), and continues
if sound is detected.
● W (Wait for dial tone)
This command waits for CO dial tone, and then continues.
● $ - Not used.
Default
✔ N (None)
[Dial Strings] External Busy Hold Retrieval
Use this option to set up the Busy External Hold Retrieval String for the External Extension feature. If voice
mail routes an External Extension transfer and the called destination is busy, it dials this string to retrieve the
call. This string is normally F.
● See EXTERNAL EXTENSION (PAGE 137) for more.
Options
● Digits (20 maximum, using 0-9, # and *)
● N (None)
● A (Analyzed pause)
This command waits for 4 seconds, and then continues if busy tone or reorder tone are not detected.
● F (Flash)
This command hook flashes the voice mail port, which places it on Hold.
- To set the duration of the Flash, go to
[TIMERS] FLASH TIMER (PAGE 474).
● M (Monitored pause)
This command waits for 2 seconds, and then continues if busy tone or reorder tone are not detected.
● P (Pause)
This command waits for 2 seconds and then continues. You can enter a pause command anywhere in
the dial string.)
● S (Wait for sound)
This command waits 2 seconds for any constant sound (such as non-standard dial tone), and continues
if sound is detected.
To Next Page
Loading...
