NEC UX5000 - Page 292

Security Code
274 ◆ Chapter 2: Features UX Mail Manual
Step 8 To automatically enable a Security Code for new mailboxes created after the initial installation:
8.1 CUSTOMIZE: SYSTEM OPTIONS: [GENERAL 1] MAILBOX DEFAULT SECURITY CODE (PAGE 458).
- This only affects new mailboxes created after the initial installation.
✔ By default, this entry is None (no default Security Code set up).
Step 9 To specify how long a caller has to enter their Security Code after voice mail requests it:
9.1 CUSTOMIZE: SYSTEM OPTIONS: [GENERAL 2] MAILBOX LOGON TIME LIMIT (PAGE 462).
- This interval also determines how long (1-99 seconds) a caller has to enter their mailbox
number after a remote logon.
✔ By default, this interval is 5 seconds.
Step 10 To specify how many times a caller can incorrectly enter a Security Code before voice mail
reroutes the call:
10.1 CUSTOMIZE: SYSTEM OPTIONS: [GENERAL 2] MAILBOX LOGON ATTEMPT LIMIT (PAGE 462).
- This interval also determines how many times (1-99 attempts) a caller can enter an incor-
rect mailbox number after a remote logon.
✔ The default setting for this option is 3.
Operation
Changing or Deleting a Security Code
(From your Subscriber Mailbox)
Log onto Subscriber Mailbox
OP (67) Access the Mailbox Options Menu
S (7) Access the Security Code options
Enter new Security Code +
#
C
(2) Accept Security Code entry and go back to the Mailbox Options
Menu
I (4) Do not accept Security Code entry and go back to the Mailbox
Options Menu
0 + # Optionally erase your Security Code and go back to the Mailbox Options Menu
#
Exit to the Mailbox Options Menu without making any changes to your Secu-
rity Code
0
Plays Help message
0
Plays Help message