NEC UX5000 - Page 352

Customize
Dial Action Tables
334 ◆ Chapter 3: Programming UX Mail Manual
Default
The following table shows the default settings for the Dial Action Tables.
Note: TIMEOUT provides the routing for rotary dial callers. See
AUTOMATIC ROUTING FOR ROTARY DIAL
CALLERS (PAGE 72) for more.
Dial Action Table Default Settings
Key Dial Action Tables 1-3 Dial Action Tables 4 and above
0UTRF to 0
(Unscreened Transfer to operator)
UTRF to 0
1
(Unscreened Transfer to operator)
1 UND
(Undefined)
UND
(Undefined)
2 UND
(Undefined)
UND
(Undefined)
3 TRF to XXX
(Screened Transfer to user-dialed extension)
UND
(Undefined)
4 TRF to XXX
(Screened Transfer to user-dialed extension)
UND
(Undefined)
5 UND
(Undefined)
UND
(Undefined)
6 UND
(Undefined)
UND
(Undefined)
7 UND
(Undefined)
UND
(Undefined)
8 UND
(Undefined)
UND
(Undefined)
9HUP
(Hang up)
UND
(Undefined)
*REC1 to IV
(Quick Message with Greeting to user-dialed
extension)
UND
(Undefined)
# LOGON
(Logon to user-dialed mailbox)
UND
(Undefined)
Timeout UTRF to 0
(Unscreened Transfer to operator)
UTRF to 0
(Unscreened Transfer to operator)