EasyManua.ls Logo

NEC UX5000 - Page 559

NEC UX5000
588 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Voice Prompts
UX Mail Manual Chapter 4: Voice Prompts 541
4
149. That number is restricted.
150. Enter the mailbox number of the message recipient you wish to check on.
151. All of your messages have been listened to.
152. _______ messages have not been listened to.
153. _______ message has not been listened to.
154. Welcome to the Mailbox Options Menu.
To change your security code, press S.
To change message notification, press N.
To change the Auto Help option, press A H.
To change the Auto Forward option, press A F.
To change the Auto Time-Stamp option, press A T.
To exit this menu, press the pound key.
155. Enter your new security code, then press the pound key.
Or, to erase your security code, press 0, then the pound key.
To exit this feature, press only the pound key.
156. You have entered too many digits. Please try again.
157. Your security code has been erased.
158. Your new security code is ______.
159. If this is correct, press C.
If this is incorrect, press I.
160. Your security code has been changed.
161. Your security code has not been changed.
162. The following network message was returned to you because ________.
163. until _______.
164. notifying you of messages from _____.
165. notifying you of all messages _____.
166. at this number _____.
167. at this radio pager number _____.
168. at this digital pager number _____.
169. ________ it was too long.
170. ________ the destination mailbox could not be found.
171. ________ the destination mailbox did not accept the message.
172. Enter the hour you wish notification to begin. You must enter a two-digit number followed by an A for AM or a P
for PM.
For example: eight AM would be entered as 0 8 A.
To skip to the next setting, press the star key.
To exit, press the pound key.
173. Enter the hour you wish notification to end. You must enter a two-digit number followed by an A for AM or a P for
PM.
For example: five PM would be entered as 0 5 P.
To skip to the next setting, press the star key.
To exit, press the pound key.
Table of Voice Prompts

Table of Contents

Other manuals for NEC UX5000

Related product manuals