Contents
R&S
®
ZNB/ZNBT
10User Manual 1173.9163.02 ─ 55
7.2.1 Device Messages (Commands and Device Responses)............................................ 748
7.2.2 SCPI Command Structure and Syntax........................................................................748
7.2.3 SCPI Parameters........................................................................................................ 752
7.3 Basic Remote Control Concepts............................................................................. 754
7.3.1 Traces, Channels, and Diagram Areas....................................................................... 754
7.3.2 Active Traces in Remote Control.................................................................................755
7.3.3 Initiating Measurements, Speed Considerations.........................................................756
7.3.4 Addressing Traces and Channels............................................................................... 757
7.4 Command Processing.............................................................................................. 758
7.4.1 Input Unit.....................................................................................................................758
7.4.2 Command Recognition................................................................................................759
7.4.3 Data Base and Instrument Hardware..........................................................................759
7.4.4 Status Reporting System............................................................................................ 760
7.4.5 Output Unit.................................................................................................................. 760
7.4.6 Command Sequence and Command Synchronization............................................... 760
7.5 Status Reporting System......................................................................................... 762
7.5.1 Overview of Status Registers......................................................................................763
7.5.2 Structure of an SCPI Status Register..........................................................................763
7.5.3 Contents of the Status Registers................................................................................ 765
7.5.4 Application of the Status Reporting System................................................................772
7.5.5 Reset Values of the Status Reporting System............................................................ 775
8 Command Reference......................................................................... 776
8.1 Special Terms and Notation..................................................................................... 776
8.1.1 Upper/Lower Case...................................................................................................... 777
8.1.2 Special Characters......................................................................................................777
8.1.3 Parameters..................................................................................................................777
8.1.4 Numeric Suffixes......................................................................................................... 777
8.2 Common Commands................................................................................................ 778
8.3 SCPI Command Reference.......................................................................................779
8.3.1 CALCulate Commands............................................................................................... 780
8.3.2 CONFigure Commands...............................................................................................989
8.3.3 CONTrol Commands...................................................................................................997
8.3.4 DIAGnostic Commands.............................................................................................1021
To Next Page
Loading...
Need help?
General
