Contents
R&S
®
ZNB/ZNBT
11User Manual 1173.9163.02 ─ 55
8.3.5 DISPlay Commands..................................................................................................1023
8.3.6 FORMat Commands................................................................................................. 1049
8.3.7 HCOPy Commands...................................................................................................1051
8.3.8 INITiate Commands.................................................................................................. 1056
8.3.9 INSTrument Commands............................................................................................1058
8.3.10 MEMory.....................................................................................................................1060
8.3.11 MMEMory Commands.............................................................................................. 1061
8.3.12 OUTPut Commands.................................................................................................. 1103
8.3.13 PROGram Commands.............................................................................................. 1108
8.3.14 [SENSe:] Commands.................................................................................................1111
8.3.15 SOURce Commands.................................................................................................1249
8.3.16 STATus Commands...................................................................................................1297
8.3.17 SYSTem Commands.................................................................................................1300
8.3.18 TRACe Commands................................................................................................... 1343
8.3.19 TRIGger Commands................................................................................................. 1346
8.4 R&S ZVR/ZVABT Compatible Commands.............................................................1353
9 Programming Examples..................................................................1379
9.1 Basic Tasks..............................................................................................................1379
9.1.1 Typical Stages of a Remote Control Program...........................................................1379
9.1.2 Channel, Trace and Diagram Handling..................................................................... 1382
9.2 Condensed Programming Examples.................................................................... 1388
9.2.1 Path Independent RC Programs............................................................................... 1389
9.2.2 Trace and Diagram Handling.................................................................................... 1389
9.2.3 Using Markers........................................................................................................... 1398
9.2.4 Data Handling........................................................................................................... 1400
9.2.5 Calibration................................................................................................................. 1404
9.2.6 Mixer Measurement.................................................................................................. 1410
9.2.7 RFFE/GPIO Interface Programming......................................................................... 1413
9.2.8 Fixture Modeling........................................................................................................1415
10 Error Messages and Troubleshooting............................................1417
10.1 Errors during Firmware Operation........................................................................ 1417
10.1.1 Asynchronous Errors.................................................................................................1418
10.1.2 Errors during Measurement...................................................................................... 1418
To Next Page
Loading...
Need help?
General
