R&S ZNB - Page 1298

Command Reference
R&S
®
ZNB/ZNBT
1298User Manual 1173.9163.02 ─ 55
STATus:PRESet
Configures the status reporting system such that device-dependent events are repor-
ted at a higher level.
The command affects only the transition filter registers, the ENABle registers, and
queue enabling:
●
The ENABle parts of the STATus:OPERation and STATus:QUEStionable... reg-
isters are set to all 1's.
●
The PTRansition parts are set all 1's, the NTRansition parts are set to all 0's,
so that only positive transitions in the CONDition part are recognized.
The status reporting system is also affected by other commands, see Chapter 7.5.5,
"Reset Values of the Status Reporting System", on page 775.
Example:
STAT:PRES
Preset the status registers.
Usage: Event
STATus:QUEStionable[:EVENt]?
STATus:QUEStionable:INTegrity[:EVENt]?
STATus:QUEStionable:INTegrity:HARDware[:EVENt]?
STATus:QUEStionable:LIMit<Lev>[:EVENt]?
These commands return the contents of the EVENt parts of the QUEStionable,
QUEStionable:INTegrity, QUEStionable:INTegrity:HARDware, and
QUEStionable:LIMit<Lev> status registers. Reading an EVENt register clears it.
Suffix:
<Lev>
.
Selects one of the two QUEStionable:LIMit registers; see
"STATus:QUEStionable:LIMit<1|2>" on page 769.
Example:
STAT:QUES:LIM1?
Query the EVENt part of the QUEStionable:LIMit1 register
to check whether an event has occurred since the last reading.
Usage: Query only
STATus:QUEStionable:CONDition?
STATus:QUEStionable:INTegrity:CONDition?
STATus:QUEStionable:INTegrity:HARDware:CONDition?
STATus:QUEStionable:LIMit<Lev>:CONDition?
Returns the contents of the CONDition part of the QUEStionable... registers.
Reading the CONDition registers is nondestructive.
Suffix:
<Lev>
.
Selects one of the two QUEStionable:LIMit registers; see
"STATus:QUEStionable:LIMit<1|2>" on page 769.
SCPI Command Reference