GUI Reference
R&S
®
ZNB/ZNBT
411User Manual 1173.9163.02 ─ 55
Restart Sweep
Stops the current measurement and restarts a measurement cycle. In "Single" sweep
mode, a new single sweep sequence is started.
Remote command:
INITiate<Ch>[:IMMediate][:DUMMy]
INITiate[:IMMediate]:ALL
Restart Manager...
If a Remote Language other than DEFAULT is selected (i.e. if some compatibility mode
is active), this button opens the Restart Manager Dialog. Otherwise it is inactive.
All Channels Continuous / All Channels on Hold
Selects a common sweep control mode for all channels of the active recall set.
●
"All Channels Continuous": The R&S ZNB/ZNBT continuously repeats the sweeps
in all channels.
●
"All Channels on Hold": The R&S ZNB/ZNBT performs single sweeps, according to
the channel-specific number of "Sweeps".
These actions are only available for the DEFAULT Remote Language). For other
remote languages (compatibility modes), you can use the Restart Manager Dialog
instead.
Remote command:
INITiate:CONTinuous:ALL
Sweep Controller
Activates/deactivates the (resizable) "Sweep Info" dialog, which displays the current
sweep stage. The "Sweep Info" dialog is particularly useful for long duration sweeps
that are executed in single sweep mode: by observing the dialog, it is easy to realize
when the sweep is done.
The possible sweep stages and how they are displayed partly depend on the selected
sweep mode (see "Continuous / Single" on page 410):
Sweep Stage Sweep Controller Display
in "Continuous" Sweep
Mode
in "Single" Sweep Mode
No ongoing sweep Idle Idle
Sweep is being prepared Preparing Preparing
Ongoing sweep
1)
Continuous Sweeping
if #Sweeps = 1
Sweep Softtool
To Next Page
Loading...
