R&S ZNB - Page 803

Command Reference
R&S
®
ZNB/ZNBT
803User Manual 1173.9163.02 ─ 55
CALCulate<Chn>:EYE:JITTer:PERiodic:MAGNitude <PeriodicMagnitude>
Defines the magnitude of the periodic jitter in the generator simulation of the relaed eye
diagram.
This command will raise an execution error if the active trace in the selected channel is
not an eye diagram.
Periodic jitter insertion can be enabled using CALCulate<Chn>:EYE:JITTer:TYPE:
PERiodic.
Suffix:
<Chn>
.
Channel number used to identify the active trace
Parameters:
<PeriodicMagnitude> *RST: 1 ns
Default unit: s
Options: R&S ZNB/ZNBT-K20
Manual operation: See "Periodic" on page 646
CALCulate<Chn>:EYE:JITTer:PERiodic:PHASe <PeriodicPhase>
Defines the phase of the periodic jitter in the generator simulation of the related eye
diagram.
This command will raise an execution error if the active trace in the selected channel is
not an eye diagram.
Periodic jitter insertion can be enabled using CALCulate<Chn>:EYE:JITTer:TYPE:
PERiodic.
Suffix:
<Chn>
.
Channel number used to identify the active trace
Parameters:
<PeriodicPhase> *RST: 0 deg
Default unit: deg
Options: R&S ZNB/ZNBT-K20
Manual operation: See "Periodic" on page 646
CALCulate<Chn>:EYE:JITTer:RANDom:STDDeviation <StdDeviation>
Defines the standard deviation of the random jitter in the generator simulation of the
related eye diagram.
This command will raise an execution error if the active trace in the selected channel is
not an eye diagram.
Random jitter insertion can be enabled using CALCulate<Chn>:EYE:JITTer:
TYPE:RANDom.
SCPI Command Reference