R&S ZNB - Page 992

Command Reference
R&S
®
ZNB/ZNBT
992User Manual 1173.9163.02 ─ 55
CONFigure:CHANnel<Ch>:NAME <ChannelName>
Assigns a name to channel number <Ch>. The channel must be created before
(CONFigure:CHANnel<Ch>[:STATe] ON). Moreover it is not possible to assign the
same name to two different channels. CONFigure:CHANnel:CATalog? returns a list
of all defined channels with their names.
Suffix:
<Ch>
.
Number of an existing channel.
Parameters:
<ChannelName> Channel name, e.g. 'Channel 4'.
*RST: 'Ch1'
Example: See CONFigure:CHANnel:CATalog?
Manual operation: See "Channel table" on page 513
CONFigure:CHANnel<Ch>:NAME:ID?
<ChannelName>
Queries the channel number (numeric suffix) of a channel with known channel name. A
channel name must be assigned before (CONFigure:CHANnel<Ch>:NAME
<ChannelName>). CONFigure:CHANnel:CATalog? returns a list of all defined
channels with their names.
Suffix:
<Ch>
.
Channel number. This suffix is not relevant and may be omitted
(the command returns the actual channel number).
Query parameters:
<ChannelName> Channel name, e.g. 'Channel 4'.
Example: See CONFigure:CHANnel:CATalog?
Usage: Query only
Manual operation: See "Table Area" on page 305
CONFigure:CHANnel<Ch>:TRACe:REName <TraceName>
Assigns a (new) name to the active trace in channel <Ch>.
Suffix:
<Ch>
.
Channel number
Setting parameters:
<TraceName> Trace name, e.g. 'Trace 4'.
SCPI Command Reference