12
TEST OPERATION
y Check to ensure that the paper chip tray is securely in place.
y Check to ensure that a Die Set is installed properly and that any extra Die Sets are securely
stored in the Die Storage Area.
y Run a small test job in “Bypass” mode. Check to ensure that the job is not punched and
bypasses properly.
y Run a small job with Punch Enabled. Check the punched holes of the job.
GBC STREAMPUNCH INSTALLATION AND SET-UP
REFERENCE ILLUSTRATION – FOR MT-C3 & VC-1 ONLY
GBC STREAMPUNCH INSTALLATION AND SET-UP
REFERENCE ILLUSTRATION - FOR BC-3
Input Guide
1
GBC Streampunch
Interconnect
Communication
Cable
To Streampunch
To Printer
Secure IC
bracket w/
wire tie-wrap
To Next Page
Loading...
