PM Tables
SM 2-7 B234/B235/B236/D101/D102/D103
Preventive
Maintenance
AROUND THE DRUM 500K 550K 1100K Exp
Side seals I
Blower brush, dry cloth
Ground plate screw I Conductivity check.
Alcohol or water
Drum dust filter C
Blower brush
Toner filter R
Cleaning unit I
Cleaning brush seal I
Cleaning entrance seal C
Blower brush, dry cloth
Cleaning brush R Section 3.7.8.
Main cleaning blade R
Cleaning unit filters R Two filters
Pre-transfer lamp C Dry cloth
ID sensor C
Drum potential sensor C
Blower brush
Quenching lamp shield glass C
Blower brush, dry cloth
Corona wire casing C
Dry cloth
Grid plate (charge) R
Charge corona wire R
Corona wire cleaner (charge) R
Wire cushion (charge) R
Pre-charge corona wire R
Pre-charge grid plate R
Drum pick-off pawls R
Transfer unit entrance stay C
Transfer belt R
Transfer belt bias brush C
Blower brush
Transfer belt and bias roller
cleaning blades
R Replace at the same time
as the transfer belt
Rear casing guide C Dry cloth
Exit bias plate C Blower brush when transfer
belt is replaced.
Belt drive roller C
Belt roller C
Alcohol, when transfer belt
is replaced.
Transfer bias roller C Alcohol, when transfer belt
is replaced. Apply
conductive grease to
electrical contacts.
Cleaning bias roller C Cleaning when Transfer
belt cleaning blade is
replaced
Ozone filter 15000K
Carrier catcher I Dry cloth
To Next Page
Loading...
