FUSING UNIT
SM 3-129 B234/B235/B236/D101/D102/D103
Replacement
Adjustment
9. Apply a small amount of grease (Barrierta S552R) to Gear Z50 [D].
Checklist
Cleaning fabric is not riding up on the metal plate?
Is the pressure lever down on the back of the fabric?
Gear Z50 clicks normally when it is turned?
No slack in the cleaning fabric between the supply and take-up rollers?
10. Place the frame unit above the fusing entrance guide plate, push it forward,
then attach it ( x1).
Important: Attach the guide plate inside without allowing any of the 4 bearings
or bushings to slip off.
11. Make sure that the fusing entrance guide plate is installed without riding up on
the pawls (x2) on the bottom of the plate.
12. If a new fabric is installed:
• Execute SP1902 001 (Fabric Motor Control> Fabric Consumption), and set
the value to 0. Switch the machine off/on after changing the setting.
To Next Page
Loading...
