MAIN SERVICE PROGRAM MODE TABLES
B234/B235/B236/D101/D102/D103 5-42 SM
4550 Scanner:Text/
4551 Scanner: Text
4552 Scanner: Dropout Color: Text
4553 Scanner: Text/Photo
4554 Scanner: Photo
4565 Scanner: Grayscale
4570 Scanner: Color: Text/Photo
4571 Scanner: Color: Photo
4572 Scanner: Auto Color
005 MTF Filter:0-15
Sets the MTF level (Modulation Transfer Function)
designed to improve image contrast. Set higher for
stronger effect, lower for weaker effect.
[0~15/1]
006 Smoothing Filter:0-7
Use to remove "jaggies" if they appear. Set higher for
smoother.
[0~7/1]
007 Brightness:1-255 Set higher for darker, set lower for lighter.
[1~255/1]
008 Contrast:1-255
Set higher for more contrast, set lower for less
contrast.
[1~255/1]
009 Isolated Dot Removal:0-7
This SP sets the level for removing dots when a color
original is scanned with a scanner software
application. The higher the setting, the greater the
effect applied for removing background dots.
[0~7/0/1]
4600 Read SBU ASIC ID
Displays the SBU ID code confirmed by reading the SBU after the SBU adjusts
automatically at power on. DFU
[0~FFFF / B550 / 0]
4605 Scanner Adjustment
001 Display Flag
Displays a flag to indicate whether density control adjustment was executed with
the standard white board for the CCD. DFU
[0~1 / 0 / 1]
0: Not executed.
1: Executed
002 Factory Start
Starts the density adjustment for the CCD using the standard white board. Place 10
sheets of A3 plain paper on the exposure glass, then press Execute. A message is
displayed to indicate the success or failure of the adjustment. DFU
To Next Page
Loading...
