Ricoh B234 - Page 613

Main Service Program Mode Tables
SM 5-75 B234/B235/B236/D101/D102/D103
Service
Tables
098
Capture Setting: Gamma SW for Backup File
Removes the ghost images transferred from the back sides of double-sided
originals.
1: Enable
0: Disable
IEEE 1394 5839
This SP is displayed only when an IEEE 1394 (firewire) card is installed.
Cycle Master 007
Enables or disables the cycle master function for the 1394 bus standard.
[0~1/1]
0: Disable (Off)
1: Enable (On)
BCR Mode 008
Determines how BCR (Broadcast Channel Register) operates on the 1394
standard bus when the independent node is in any mode other than IRM.
(NVRAM: 2-bits)
[Always Effective]
IRM 1394a Check 009
Conducts a 1394a check of IRM when the independent node is in any mode
other than IRM.
[0~1/1]
0: Checks whether IRM conforms to 1394a
1: After IRM is checked, if IRM does not conform then independent node
switches to IRM.
Unique ID 010
Lists the ID (Node_Unique_ID) assigned to the device by the system
administrator.
Bit0: Off
Bit1: On
OFM: Does not list the Node_Unique_ID assigned by the system administrator.
Instead, the Source_ID of the GASP header in the ARP is used.
ON: The Node_Unique_ID assigned by the system administrator is used, and
the Source_ID of the GASP header in the ARP is ignored. Also, when the
serial bus is reset, extra bus transactions are opened for the enumeration.
Logout 011
Handles the login request of the login initiator for SBP-2. (1-bit)
Bit0: Off
Bit1: On
OFM: Disable (refuse login). Initiator retry during login. Login refusal on arrival of
login request (standard operation)
ON: Enable (force logout). Initiator retry during login. Login refusal on arrival of
login request, and the initiator forces the login.
Login 012
Enables or disables the exclusive login feature (SBP-2 related).
Bit0: Off
Bit1: On
OFM: Disables. The exclusive login (LOGIN ORB exclusive it) is ignored.
ON: Enables. Exclusive login is in effect.