Main Service Program Mode Tables
SM 5-77 B234/B235/B236/D101/D102/D103
Service
Tables
5844 USB
Transfer Rate 001
Sets the speed for USB data transmission.
[Full Speed]
[Auto Change]
Vendor ID 002
Sets the vendor ID:
Initial Setting: 0x05A Ricoh Company
[0x0000~0xFFFF/1] DFU
Product ID 003
Sets the product ID.
[0x0000~0xFFFF/1] DFU
Device Release No. 004
Sets the device release number of the BCD (binary coded decimal) display.
[0000~9999/1] DFU
Enter as a decimal number. NCS converts the number to hexadecimal number
recognized as the BCD.
Delivery Server Setting 5845
These are delivery server settings.
FTP Port No. 001
[0~65535/1]
IP Address 002
Use this SP to set the Scan Router Server address. The IP address under the
transfer tab can be used with the initial system setting.
[0~FFFFFFFF/1]
Capture Server IP Address 005
Sets the IP address that is assigned to the PC that the capture server (eCabinet
or Scan Router) operates. This IP address is set remotely when the delivery
server (Scan Router) IO device is registered. This SP only enables the IP
address permit access to the DNS browser names.
Delivery Error Display Time 006
Use this setting to set the length of time that the message is shown when a test
error occurs during document transfer with the NetFile application and an
external device.
[0~999/1]
IP Address (Secondary) 008
Sets the IP address that is given to the computer that is the secondary delivery
server for Scan Router. This SP lets you set only the IP address, and does not
refer to the DNS setting.
To Next Page
Loading...
