MAIN SERVICE PROGRAM MODE TABLES
B234/B235/B236/D101/D102/D103 5-80 SM
Addr Book Migration (SD -> HDD) 040
This SP moves the address book data from an SD card to the HDD. You must
cycle the machine off and on after executing this SP.
1. Turn the machine off.
2. Install the HDD.
3. Insert the SD card with the address book data in SD card Slot.
4. Turn the machine on.
5. Do SP5846 040.
6. Turn the machine off.
7. Remove the SD card from SD card Slot.
8. Turn the machine on.
Notes:
• Executing this SP overwrites any address book data already on the HDD with
the data from the SD card.
• We recommend that you back up all directory information to an SD card with
SP5846 051 before you execute this SP.
• After the address book data is copied to HDD, all the address book data is
deleted from the source SD card. If the operation fails, the data is not erased
from the SD card.
Fill Addr Acl Info. 041
This SP must be executed immediately after installation of an HDD unit in a basic
machine that previously had no HDD. The first time the machine is powered on
with the new HDD installed, the system automatically takes the address book
from the NVRAM and writes it onto the new HDD. However, the new address
book on the HDD can be accessed only by the system administrator at this stage.
Executing this SP by the service technician immediately after power on grants full
address book access to all users.
Procedure
1. Turn the machine off.
2. Install the new HDD.
3. Turn the machine on.
4. The address book and its initial data are created on the HDD automatically.
However, at this point the address book can be accessed by only the system
administrator or key operator.
5. Enter the SP mode and do SP5846 041. After this SP executes successfully,
any user can access the address book.
Initialize All Settings & Address Book DFU 046
The SP clears all the setting information managed in UCS and address book
information (local, delivery, LDAP) and restores these settings to their default
values. Use this SP to initial the account information (user codes and passwords)
for system managers and users as well.
Note:
• Be sure to cycle the machine off and on after you execute this SP code.
• Once this SP has been executed, a message on the screens of applications
that use the address book will prompt users that the address book is being
updated. This prevents the machine from issuing SC870.
• The machine initializes to determine if the address book is stored on the HDD
or on an SD card. In order for the machine to determine whether to recognize
an address book on the HDD or the SD card, the machine must be cycled off
and on once more to determine whether the machine should recognize the
address book on the HDD or the SD card.
To Next Page
Loading...
