MEMORY ALL CLEAR: SP5801
B234/B235/B236/D101/D102/D103 5-186 SM
4. Press Execute, then follow the prompts on the display to complete the
procedure.
5. Make sure that you perform the following settings:
• Do the printer and scanner registration and magnification adjustments.
( 3-17).
• Execute SP2115 – Main Scan Beam Pitch Adjustment
• Do the touch screen calibration ( Section 3 “Touch Screen Calibration”).
• Referring to the SMC data lists, re-enter any values, which had been changed
from their factory settings.
• Execute SP 3001 002 – ID Sensor Initial Setting
• Switch SP 3901 001 (Auto Process Control Setting) to 1 (On), if you wish auto
process control to be used.
6. Check the copy quality and the paper path, and do any necessary adjustments.
To Next Page
Loading...
