Siemens SINAMICS G120D - Page 11

Overview of parameters
Parameters
1-11
© Siemens AG 2012 - 2013 All Rights Reserved
SINAMICS G120D List Manual (LH14), 01/2013
CU/PM variants
Indicates for which Control Units (CU) and/or Power Modules (PM) the parameter
is valid. If no CU or PM is listed, then the parameter is valid for all variants.
The following information relating to "CU" and "PM" can be displayed under the
parameter number:
Access level
Specifies the minimum access level required to be able to display and change the
relevant parameter. The required access level can be set using p0003.
The system uses the following access levels:
• 1: Standard (not adjustable, included in p0003 = 3)
• 2: Extended (not adjustable, included in p0003 = 3)
• 3: Expert
• 4: Service
Parameters with this access level are password protected.
Table 1-1 Information in the "CU/PM variants" field
CU/PM variants Significance
All Control Units have this parameter.
CU240D-2_DP CU240D-2 with PROFIBUS interface
CU240D-2_DP_F CU240D-2 with PROFIBUS interface and PROFIsafe
CU240D-2_PN CU240D-2 with PROFINET interface
CU240D-2_PN_F CU240D-2 with PROFINET interface and PROFIsafe
CU250D-2_DP CU250D-2 with PROFIBUS interface
CU250D-2_DP_F CU250D-2 with PROFIBUS interface and PROFIsafe
CU250D-2_PN CU250D-2 with PROFINET interface
CU250D-2_PN_F CU250D-2 with PROFINET interface and PROFIsafe
Note:
Parameter p0003 is CU-specific (available on the Control Unit).
A higher access level will also include the functions of the lower levels.