Siemens SINAMICS G120D - r2074[0...11] PROFIdrive diagnostics bus address PZD receive; Diag addr recv; r2075[0...11] PROFIdrive diagnostics telegram offset PZD receive; Diag offs recv; r2076[0...13] PROFIdrive diagnostics telegram offset PZD send; Diag offs send

Parameters
List of parameters
1-262
© Siemens AG 2012 - 2013 All Rights Reserved
SINAMICS G120D List Manual (LH14), 01/2013
Description: Displays the PROFIBUS address of the sender from which the process data (PZD) is received.
Index: [0] = PZD 1
[1] = PZD 2
[2] = PZD 3
[3] = PZD 4
[4] = PZD 5
[5] = PZD 6
[6] = PZD 7
[7] = PZD 8
[8] = PZD 9
[9] = PZD 10
[10] = PZD 11
[11] = PZD 12
Note: Value range:
0 - 125: Bus address of the sender
65535: not assigned
Description: Displays the PZD byte offset in the PROFIdrive receive telegram (controller output).
Index: [0] = PZD 1
[1] = PZD 2
[2] = PZD 3
[3] = PZD 4
[4] = PZD 5
[5] = PZD 6
[6] = PZD 7
[7] = PZD 8
[8] = PZD 9
[9] = PZD 10
[10] = PZD 11
[11] = PZD 12
Note: Value range:
0 - 242: Byte offset
65535: not assigned
Description: Displays the PZD byte offset in the PROFIdrive send telegram (controller input).
r2074[0...11] PROFIdrive diagnostics bus address PZD receive / Diag addr recv
Access level: 3 Calculated: - Data type: Unsigned16
Can be changed: - Scaling: - Dyn. index: -
Units group: - Unit selection: - Func. diagram: -
Min Max Factory setting
- - -
r2075[0...11] PROFIdrive diagnostics telegram offset PZD receive / Diag offs recv
Access level: 3 Calculated: - Data type: Unsigned16
Can be changed: - Scaling: - Dyn. index: -
Units group: - Unit selection: - Func. diagram: -
Min Max Factory setting
- - -
r2076[0...13] PROFIdrive diagnostics telegram offset PZD send / Diag offs send
Access level: 3 Calculated: - Data type: Unsigned16
Can be changed: - Scaling: - Dyn. index: -
Units group: - Unit selection: - Func. diagram: -
Min Max Factory setting
- - -