Siemens SINAMICS G120D - p2511[0...3] BI: LR measuring probe evaluation edge; MT_eval edge; p2512[0...3] BI: LR pos. actual value preprocessing activate corr. value (edge); ActVal_prepCorrAct; p2513[0...3] CI: LR Position actual value preprocessing corrective value; Act val_prep corr

Parameters
List of parameters
1-320
© Siemens AG 2012 - 2013 All Rights Reserved
SINAMICS G120D List Manual (LH14), 01/2013
Description: Sets the signal source for the edge evaluation of the measuring probe.
1 signal = falling edge of the measuring probe (p2510) is activated for BI: p2509 = 0/1 edge.
0 signal = rising edge of the measuring probe (p2510) is activated for BI: p2509 = 0/1 edge.
Index: [0] = Cl-loop pos ctrl
[1] = Encoder 1
[2] = Encoder 2
[3] = Reserved
Dependency: Refer to: p2502, p2509, p2510
Description: Sets the signal source for the function "activate position actual value preprocessing, corrective value (edge)".
0/1 signal: The corrective value available through CI: p2513 is activated.
Index: [0] = Cl-loop pos ctrl
[1] = Encoder 1
[2] = Encoder 2
[3] = Reserved
Dependency: Refer to: p2502, p2513, r2684
Description: Sets the signal source for the corrective value for position actual value preprocessing.
Index: [0] = Cl-loop pos ctrl
[1] = Encoder 1
[2] = Encoder 2
[3] = Reserved
Dependency: Refer to: p2502, p2512, r2521, r2685
Note: For BI: p2512[0] = 0/1 signal, the position actual value (CO: r2521[0]) is corrected corresponding to the value via CI:
p2513[0]. In so doing, the sign of the corrective value present is taken into account.
p2511[0...3] BI: LR measuring probe evaluation edge / MT_eval edge
CU250D-2_DP_F
CU250D-2_PN_F
Access level: 1 Calculated: - Data type: U32 / Binary
Can be changed: T Scaling: - Dyn. index: -
Units group: - Unit selection: - Func. diagram: 3615, 4010
Min Max Factory setting
- - 0
p2512[0...3] BI: LR pos. actual value preprocessing activate corr. value (edge) /
ActVal_prepCorrAct
CU250D-2_DP_F
CU250D-2_PN_F
Access level: 1 Calculated: - Data type: U32 / Binary
Can be changed: T Scaling: - Dyn. index: -
Units group: - Unit selection: - Func. diagram: 4010, 4015
Min Max Factory setting
- - [0] 2684.7
[1] 0
[2] 0
[3] 0
p2513[0...3] CI: LR Position actual value preprocessing corrective value / Act val_prep corr
CU250D-2_DP_F
CU250D-2_PN_F
Access level: 1 Calculated: - Data type: U32 / Integer32
Can be changed: T Scaling: - Dyn. index: -
Units group: - Unit selection: - Func. diagram: 4010, 4015
Min Max Factory setting
- - [0] 2685[0]
[1] 0
[2] 0
[3] 0