Siemens SINAMICS G120D - p2614 BI: EPOS search for reference reversing cam plus; Rev plus; p2615 EPOS maximum number of traversing blocks; Trav_block qty max; p2616[0...n] EPOS traversing block block number; Trav_blk, blkNo.; p2617[0...n] EPOS traversing block position; Trav_block pos

Parameters
List of parameters
1-348
© Siemens AG 2012 - 2013 All Rights Reserved
SINAMICS G120D List Manual (LH14), 01/2013
Description: Sets the signal source for the reversing cam in the negative direction of travel.
1 signal: Reversing cam not reached.
0 signal: Reversing cam reached.
Dependency: Refer to: p2613
Note: If, during the search for reference from the reversing cam minus and plus, a 0 signal is detected, then the axis
remains stationary (at standstill).
Description: Sets the maximum number of traversing blocks that are available.
Dependency: Refer to: p2616, p2617, p2618, p2619, p2620, p2621, p2622, p2623, p2624
Description: Sets a block number.
-1: Invalid block number. These blocks are not taken into account.
0 ... 15: Valid block number.
Dependency: The number of indices depends on p2615.
Refer to: p2615, p2617, p2618, p2619, p2620, p2621, p2622, p2623, p2624
Description: Sets the target position for the traversing block.
Dependency: The number of indices depends on p2615.
Refer to: p2615, p2616, p2618, p2619, p2620, p2621, p2622, p2623, p2624
Note: The target position is approached in either relative or absolute terms depending on p2623.
p2614 BI: EPOS search for reference reversing cam plus / Rev plus
CU250D-2_DP_F
CU250D-2_PN_F
Access level: 1 Calculated: - Data type: U32 / Binary
Can be changed: T Scaling: - Dyn. index: -
Units group: - Unit selection: - Func. diagram: 3612
Min Max Factory setting
- - 1
p2615 EPOS maximum number of traversing blocks / Trav_block qty max
CU250D-2_DP_F
CU250D-2_PN_F
Access level: 1 Calculated: - Data type: Unsigned8
Can be changed: C(17) Scaling: - Dyn. index: -
Units group: - Unit selection: - Func. diagram: 3616
Min Max Factory setting
1 16 16
p2616[0...n] EPOS traversing block block number / Trav_blk, blkNo.
CU250D-2_DP_F
CU250D-2_PN_F
Access level: 1 Calculated: - Data type: Integer16
Can be changed: U, T Scaling: - Dyn. index: p2615
Units group: - Unit selection: - Func. diagram: 3616
Min Max Factory setting
-1 15 -1
p2617[0...n] EPOS traversing block position / Trav_block pos
CU250D-2_DP_F
CU250D-2_PN_F
Access level: 1 Calculated: - Data type: Integer32
Can be changed: U, T Scaling: - Dyn. index: p2615
Units group: - Unit selection: - Func. diagram: 3616
Min Max Factory setting
-2147482648 [LU] 2147482647 [LU] 0 [LU]