Siemens SINAMICS G120D - 3.1.2 Explanation of the list of faults and alarms

Faults and alarms
Overview of faults and alarms
3-772
© Siemens AG 2012 - 2013 All Rights Reserved
SINAMICS G120D List Manual (LH14), 01/2013
3.1.2 Explanation of the list of faults and alarms
The data in the following example has been chosen at random. The information
listed below is the maximum amount of information that a description can contain:
Some of the information is optional.
The list of faults and alarms (See Chapter 3.2) is structured as follows:
Axxxxx Alarm xxxxx
Axxxxx (F, N) Alarm xxxxx (message type can be changed to F or N)
Fxxxxx Fault xxxxx
Fxxxxx (A, N) Fault xxxxx (report type can be changed to A or N)
Nxxxxx No message
Nxxxxx (A) No message (message type can be changed to A)
Cxxxxx Safety message (separate message buffer)
A message comprises a letter followed by the relevant number.
The meaning of the letters is as follows:
• A means "Alarm".
• F means "Fault".
• N means "No message" or "Internal message".
• C means "Safety message"
The optional parentheses indicate whether the type specified for this message
can be changed and which message types can be adjusted via parameters
(p2118, p2119).
Information on reaction and acknowledgment is specified independently for a
message with an adjustable message type (e.g. reaction to F, acknowledgement
for F).
- - - - - - - - - - - - - - - - - - - - - - - - - Start of example - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - -
Axxxxx (F, N) Fault location (optional): Name
Reaction: NONE
Acknowledg-
ment:
NONE
Cause: Description of possible causes
Fault value (r0949, interpret format): or alarm value (r2124, interpret format): (optional)
Information about fault or alarm values (optional)
Remedy: Description of possible remedies
- - - - - - - - - - - - - - - - - - - - - - - - - End of example - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - -