Parameters
List of parameters
1-480
© Siemens AG 2012 - 2013 All Rights Reserved
SINAMICS G120D List Manual (LH14), 01/2013
Description: Sets the signal source of input quantities X0, X1, X2, X3 of instance ADD 0 of the adder.
Index: [0] = Input X0
[1] = Input X1
[2] = Input X2
[3] = Input X3
Description: Display parameter for the output quantity Y = X0 + X1 + X2 + X3 of instance ADD 0 of the adder.
Description: Setting parameter for the run-time group in which the instance ADD 0 of the adder is to be called.
Value: 5: Run-time group 5
6: Run-time group 6
9999: Do not calculate
Description: Setting parameter for the run sequence of instance ADD 0 within the run-time group set in p20096.
Note: The function blocks with a lower run sequence value are calculated before function blocks with a higher run
sequence value.
p20094[0...3] CI: ADD 0 inputs / ADD 0 inputs
CU240D-2_DP
CU240D-2_DP_F
CU240D-2_PN
CU240D-2_PN_F
Access level: 3 Calculated: - Data type: U32 / FloatingPoint32
Can be changed: T Scaling: PERCENT Dyn. index: -
Units group: - Unit selection: - Func. diagram: 7220
Min Max Factory setting
- - 0
r20095 CO: ADD 0 output Y / ADD 0 output Y
CU240D-2_DP
CU240D-2_DP_F
CU240D-2_PN
CU240D-2_PN_F
Access level: 3 Calculated: - Data type: FloatingPoint32
Can be changed: - Scaling: PERCENT Dyn. index: -
Units group: - Unit selection: - Func. diagram: 7220
Min Max Factory setting
- - -
p20096 ADD 0 run-time group / ADD 0 RTG
CU240D-2_DP
CU240D-2_DP_F
CU240D-2_PN
CU240D-2_PN_F
Access level: 3 Calculated: - Data type: Integer16
Can be changed: T Scaling: - Dyn. index: -
Units group: - Unit selection: - Func. diagram: 7220
Min Max Factory setting
5 9999 9999
p20097 ADD 0 run sequence / ADD 0 RunSeq
CU240D-2_DP
CU240D-2_DP_F
CU240D-2_PN
CU240D-2_PN_F
Access level: 3 Calculated: - Data type: Unsigned16
Can be changed: T Scaling: - Dyn. index: -
Units group: - Unit selection: - Func. diagram: 7220
Min Max Factory setting
0 32000 210
To Next Page
Loading...
