Siemens SINAMICS G120D - Page 16

Parameters
Overview of parameters
1-16
© Siemens AG 2012 - 2013 All Rights Reserved
SINAMICS G120D List Manual (LH14), 01/2013
Function diagram
The parameter is included in this function diagram. The structure of the parameter
function and its relationship with other parameters is shown in the specified func-
tion diagram.
Parameter values
Description
Explanation of the function of a parameter
Values
Lists the possible values of a parameter.
Recommendation
Information about recommended settings.
Table 1-5 Unit group (p0595)
Unit group Unit selection for p0595 = Reference value
for %
Value Unit
9_1 The values that can be set and the technological units are shown in
p0595 (See Chapter 1.2).
Min Minimum value of the parameter [unit]
Max Maximum value of the parameter [unit]
Factory setting Value when shipped [unit]
In the case of a binector/connector input, the signal source
of the default BICO interconnection is specified. A non-
indexed connector output is assigned the index [0].
A different value may be displayed for certain parameters
(e.g. p1800) during first commissioning.
Reason:
The setting for these parameters is determined by the
operating environment of the Control Unit (e.g. by the device
type, or power unit).