Parameters
Quick commissioning (p0010 = 1)
1-570
© Siemens AG 2012 - 2013 All Rights Reserved
SINAMICS G120D List Manual (LH14), 01/2013
If p0010 = 1 is selected, p0003 (user access level) can be used to select the parameters that
are to be accessed.
At the end of the quick commissioning, set p3900 = 1 to perform the required motor calcula-
tions and reset all other parameters (not included in p0010 = 1) to their default settings.
p1300 Open-loop/closed-loop control operating mode 2 C(1)T
p1500 Torque setpoint selection 2 C(1)T
p1900 Motor data identification and rotating measurement 1 C(1)T
p1905 Parameter tuning selection 1 C(1)T
p2196 Torque utilization scaling 1 C(1,3)UT
p3900 Completion of quick commissioning 1 C(1)
Note:
This only applies for the quick commissioning.
Table 1-7 Quick commissioning (p0010 = 1), continued
Par. no. Name Access level Change-
able
To Next Page
Loading...
