Siemens SINAMICS G120D - Page 902

Index
C-902
© Siemens AG 2012 - 2013 All Rights Reserved
SINAMICS G120D List Manual (LH14), 01/2013
6799
Display signals, 2-714
7200
Sampling times of the runtime groups,
2-716
7210
AND (AND function blocks with 4 inputs),
2-717
7212
OR (OR function blocks with 4 inputs),
2-718
7214
XOR (XOR function blocks with 4 inputs),
2-719
7216
NOT (inverter), 2-720
7220
ADD (adder with 4 inputs),
SUB (subtracter), 2-721
7222
MUL (multiplier with 4 inputs),
DIV (divider), 2-722
7224
AVA (absolute value generator), 2-723
7225
NCM (numeric comparator), 2-724
7226
PLI (polyline scaling), 2-725
7230
MFP (pulse generator),
PCL (pulse contractor), 2-726
7232
PDE (ON delay), 2-727
7233
PDF (OFF delay), 2-728
7234
PST (pulse stretcher), 2-729
7240
RSR (RS flip-flop),
DFR (D flip-flop), 2-730
7250
BSW (binary change-over switch),
NSW (numeric change-over switch),
2-731
7260
LIM (limiter), 2-732
7262
PT1 (smoothing element), 2-733
7264
INT (integrator),
DIF (derivative-action element), 2-734
7270
LVM (double-sided limit monitor with hys-
teresis), 2-735
7950
Fixed values, binary selection
(p2216 = 2), 2-740
7951
Fixed values, direct selection (p2216 = 1),
2-741
7954
Motorized potentiometer, 2-742
7958
Control modes, 2-743
8005
Overview, signals and monitoring func-
tions, 2-745
8010
Speed messages 1, 2-746
8011
Speed messages 2, 2-747
8012
Torque signals, motor locked/stalled,
2-748
8013
Load monitoring, 2-749
8014
Thermal monitoring, power unit, 2-750
8016
Thermal monitoring, motor, 2-751
8017
Thermal motor models, 2-752
8020
Monitoring functions 1, 2-753
8021
Monitoring functions 2, 2-754
8050
Overview of Faults and Alarms, 2-756
8060
Fault buffer, 2-757
8065
Alarm buffer, 2-758
8070
Fault/alarm trigger word (r2129), 2-759
8075
Fault/alarm configuration, 2-760
8550
Data set overview, 2-762
8560
Command data sets
(CDS), 2-763
8565
Drive data s
ets
(DDS), 2-764