RM0008 Real-time clock (RTC)
Doc ID 13902 Rev 12 465/1096
18.2 RTC main features
● Programmable prescaler: division factor up to 2
20
●
32-bit programmable counter for long-term measurement
● Two separate clocks: PCLK1 for the APB1 interface and RTC clock (must be at least
four times slower than the PCLK1 clock)
● The RTC clock source could be any of the following ones:
– HSE clock divided by 128
– LSE oscillator clock
– LSI oscillator clock (refer to Section 7.2.8: RTC clock for details)
● Two separate reset types:
– The APB1 interface is reset by system reset
– The RTC Core (Prescaler, Alarm, Counter and Divider) is reset only by a Backup
domain reset (see Section 7.1.3: Backup domain reset on page 88).
● Three dedicated maskable interrupt lines:
– Alarm interrupt, for generating a software programmable alarm interrupt.
– Seconds interrupt, for generating a periodic interrupt signal with a programmable
period length (up to 1 second).
– Overflow interrupt, to detect when the internal programmable counter rolls over to
zero.
To Next Page
Loading...
Need help?
General
