Trimble S - Trimble eProtectTM - PIN;PUK code security; PIN Code; PUK Code; Face2 display start-up menu

Chapter 3
Theory of Operation
P/N 57150002, Revision 5.0 3 - 59 Trimble S, VX, SPS & RTS Service Manual
F
Trimble eProtect
TM
- PIN/PUK code security
Function available for Trimble S8, VX & SPS instruments.
Note – This function requires firmware R10.0.58 or higher.
To avoid unauthorized use of the Trimble S8, VX & SPS instruments a PIN/PUK security code can
be activated by the user.
For more information how to activate/change PIN code or how to enter PUK code see the User Guide,
Setup chapter.
PIN Code
The PIN Code is a four digit code where each digit can be set between 0-9 e.g. “1234”. The PIN Code
can be activated and changed by the user.
As default the PIN Code is not active and is set to “0000”. A function in PASS can be used to read
out the PIN code if the PIN code is activated, see page 6-178.
Note – If the wrong code is entered more than 10 times, the instrument will be locked and the PUK
Code needs to be entered.
PUK Code
The PUK Code is a ten digit code where each digit is set between 0-9 e.g. "0123456789".
The PUK Code can not be changed by the user.
The PUK Code is set at the factory. A document with the PUK Code is supplied to the user when the
instrument is delivered. The PUK code can be generated in the PASS service software, see page 6-
178.
Note – The PUK Code is needed to unlock the instrument if wrong PIN Code has been entered more
than ten times.
Face2 display start-up menu
When starting up the instrument depending on the model different options are available.
The face2 display menus described below can only be accessed when there is no Trimble CU
attached, please remove the Trimble CU before starting the instrument.
See the instrument User Guide, Setup chapter for more information about the face 2 display menu.
Trimble S6 & VX menus
Setup/Level - Trimble S6 & VX Setup & level menu.
Unlock instrument - If security (PIN-code) is activated.