Chapter 1
General Information and safety
Trimble S, VX, SPS & RTS Service Manual1 - 8 P/N 57150002, Revision 5.0
F
Laser Safety
Class I, II, and IIIa laser products are defined by the U.S. Bureau of Radiological Health.
C
Warning – Use of controls or adjustments or performance of procedures other than those
specified herein may result in hazardous LED or laser radiation exposure. As with any bright light
source, such as the sun, electric welding arcs or arc lamps, common sense applies. Avoid direct
eye exposure when the laser is on. For further information regarding safe use of lasers, refer to
the CEI/IEC standard 60825-1:2007.
This equipment has been tested and found to comply with CEI/IEC 60825-1:2007, 21 CFR 1040.10,
and 1040.11 except for deviations to Laser Notice No. 50, dated June 24, 2007.
If the instrument is equipped with a high power laser, this equipment has been tested and found to
comply with IEC 60825-1 2007, 21 CFR 1040.10, and 1040.11 except for deviations to Laser Notice
No. 50, dated June 24, 2007.
Queries
Address any questions you may have about laser safety to:
Trimble Navigation Limited 5475 Kellenburger Road Dayton, OH USA 45424-1099 Attention:
Laser Safety Officer, Quality Assurance Group Phone (937) 233-8921 ext 5824 or (800) 538-7800
Fax (937) 233-9661
Trimble S3 DR / RTS555 DR / RTS655 DR / SPS620 DR / SPS720 DR
The Trimble S3 DR, RTS555 DR , RTS655 DR, SPS620 DR, SPS720 DR Total Stations are CLASS
3R LASER PRODUCT:
Fig. 1-2 Laser warning label
Fig. 1-3 Laser aperture label
To Next Page
Loading...
Need help?
General
