Chapter 6
Adjustment and verification
P/N 57150002, Revision 5.0 6 - 203 Trimble S, VX, SPS & RTS Service Manual
F
Service check list
• Trimble S3 Check list after service/repair
• Trimble S6 Check list after service/repair
• Trimble S8 Check list after service/repair
• Trimble VX Check list after service/repair
• Trimble RTS Check list after service/repair
• Trimble SPS Check list after service/repair
• Service interval check list
• Delivery test
This chapter includes a check list and a delivery test protocol. the checklist is a guide to be used after
service / calibration of the instrument. the delivery test protocol should be used to test an instrument
before delivery to the customer.
For information what to do after replacing a service part / module, see page 5-148.
Trimble S3 Check list after service/repair
Trimble S6 Check list after service/repair
[ ] 1. Perform Tilt sensor offset, see page 6-29
[ ] 2. Perform HA/VA collimation, see page 6-47
[ ] 3. Perform Trunnion axis correction, see page 6-48
[ ] 4. Perform Tracker collimation test, see page 6-147
[ ] 5. Perform Vertical oscillation compensation, see page 6-25
[ ] 6. Check distances on baselines
[ ] 7. Radio range & short range test, see page 6-3.
[ ] 8. Set service interval, see page 6-201
[ ] 9. Save constants, see page 6-6
[ ] 10. Save event log, see page 4-2
[ ] 11. Clear event log, see page 4-4
[ ] 1. Perform Tilt sensor offset, see page 6-29
[ ] 2. Perform HA/VA collimation, see page 6-47
[ ] 3. Perform Trunnion axis correction, see page 6-48
[ ] 4. Perform Auto focus calibration, see page 6-180
[ ] 5. Perform Tracker collimation test, see page 6-147
To Next Page
Loading...
Need help?
General
