7. Change the size of the Volume box by moving the trackball.
Moving:
↑ decrease the box size in vertical direction
↓ increase the box size in vertical direction
→ increase the box size in horizontal direction
← decrease the box size in horizontal direction
8. Set the volume sweep angle by using the right control below the menu area.
9. Select the Quality. This function changes the line density against acquisition speed.
10. Start Real Time 4D Biopsy with the [Freeze]
key or the right trackball key (Start ->
displayed in Status bar area on the monitor).
The acquisition starts and the 4D Biopsy menu appears.
11. Press the [Freeze] key again to stop the acquisition. review: After the Real Time 4D Biopsy
(chapter
'After the Real Time 4D Biopsy'
on page 9-116
)
9.11.1 Real Time 4D Biopsy Controls
Select the 3D Orientation (Mirror View)
With this function it is possible to change the render-view direction (green line) to the opposite
side. Switch on/off the Mirror View.
For further controls and possible adjustments, review 4D Controls
(chapter
'4D Controls'
on
page 9-92
)
.
Volume Mode
Voluson® S6/S8 Basic User Manual
5433669-100 Revision 4 9-115
To Next Page
Loading...
