Remark: To select the Doppler measuring results, which should be displayed after the
measurement (= “Auto/Manual Trace”) and to select if the envelope curve will be performed
with a continuous trace line or by setting points (= “Manual Trace Mode”), review: Application
Parameters
(chapter
'The Measure Setup Pages'
on page 11-109
).
11.2.5.27 To measure the Items One by One
To measure the Item such as Peak E + A, Dec Time, PHT, IVRT:
1. Press the [Calc] key on the control panel.
2. Select [MV] and then select the appropriate item.
3. Perform the measurements by using the trackball and the right or left trackball key [Set].
11.2.5.28 AV (Aortic Valve)
There are different methods to perform measurements and calculations of the Aortic Valve in
the Spectral-Doppler mode. The measurement methods are similar to those of the Mitral
Valve.
For further details, review: MV (Mitral Valve)
(chapter
'MV (Mitral Valve)'
on page 11-75
)
Measurements and Patient Worksheets (Reports)
11-76
Voluson® S6/S8 Basic User Manual
5433669-100 Revision 4
To Next Page
Loading...
