GE Voluson S8 - 11.2.10.2 Before starting Neurology Calculations; 11.2.10.3 Neurology Calculations in 2 D Mode; 11.2.10.4 Neurology Calculations in M Mode; 11.2.10.5 Neurology Calculations in Spectral-Doppler Mode

11.2.10.2 Before starting Neurology Calculations
1. Press the [Patient] key on the control panel, select the [NEURO] page and enter all patient
information for Neurology calculations. For details refer to: Entering Patient Data
(chapter
'Entering Patient Data' on page 4-10 )
Note To cancel all calculations performed before and to start new measurement, press this key and
select [End Exam] or [Clear Exam].
2. Press [Start Exam].
3. Make sure that the probe and application are selected properly. If another application is
selected, press the [Probe]
key on the control panel, and change it to Neurology. For details
refer to:
Probe/Program Selection
(chapter 'Probe/Program Selection' on page 4-7 )
11.2.10.3 Neurology Calculations in 2D Mode
•
Distance Measurements (e.g., Flow Diameter)
•
Vessel Area/Vessel Diameter
•
Stenosis Area/Stenosis Diameter
The measurement procedures in 2D Mode are the same than in application “Abdomen”.
Review: Abdomen Calculations in 2D Mode in
'Abdomen Calculations' on page 11-24 .
11.2.10.4 Neurology Calculations in M Mode
•
Vessel Diameter
•
Stenosis Diameter
•
Time
•
HR (Heart Rate)
The measurement procedures in M Mode are the same than in application “Abdomen”.
Review: Abdomen Calculations in M Mode in 'Abdomen Calculations' on page 11-24 .
11.2.10.5 Neurology Calculations in Spectral-Doppler Mode
•
Auto Trace
Measurements and Patient Worksheets (Reports)
Voluson® S6/S8 Basic User Manual
5433669-100 Revision 4 11-95