1. Press the [Patient] key on the control panel, select the [GYN] page and enter all patient
information for Gynecology calculations (e.g., expected Ovulation). For details refer to:
Entering Patient Data
(chapter
'Entering Patient Data'
on page 4-10
)
Note
To cancel all calculations performed before and to start new measurement, press this key and
select [End Exam] or [Clear Exam].
2. Press [Start Exam].
3. Make sure that the probe and application are selected properly. If another application is
selected, press the [Probe]
key on the control panel, and change it to Gynecology. For details
refer to:
Probe/Program Selection
(chapter
'Probe/Program Selection'
on page 4-7
)
11.2.8.3 Gynecology Calculations in 2D Mode
•
Distance Measurements (like Length, Endo. Thickness, etc.)
•
Angular Measurements like (urethal rotation)
•
Area Measurements (like Levator hiatus stress)
The measurement procedures in 2D Mode are the same than in application “Abdomen”.
Review: Abdomen Calculations in 2D Mode in
'Abdomen Calculations'
on page 11-24
.
11.2.8.4 Gynecology Calculations in M Mode
•
Vessel Diameter
•
Stenosis Diameter
•
Time
•
HR (Heart Rate)
The measurement procedures in M Mode are the same than in application “Abdomen”.
Review: Abdomen Calculations in M Mode in
'Abdomen Calculations'
on page 11-24
.
11.2.8.5 Gynecology Calculations in Spectral-Doppler Mode
•
Auto Trace
•
Manual Trace
•
Measurement of Each Item
•
Measurement of PS/ED RI+SD
•
Time
•
HR (Heart Rate)
Measurements and Patient Worksheets (Reports)
Voluson® S6/S8 Basic User Manual
5433669-100 Revision 4 11-89
To Next Page
