For additional description please refer to Basic Patient Worksheet Functions
(chapter
'Basic
Patient Worksheet Functions'
on page 11-101
)
.
11.2.9 Pediatric Calculations
Application “Pediatrics”, (Factory - Sub Category: Default) allows measurements/calculations
in 2D/3D mode, M mode and Spectral-Doppler mode, using various measure items. For details
about settings, review: Measure Setup -
Measure & Calc
(chapter
'The Measure Setup Pages'
on page 11-109
)
The methods for obtaining measurements in the Pediatrics Calculations menu are similar to
the generic measurement functions in 2D, M and Spectral Doppler mode.
11.2.9.1 Items of Pediatric Calculations
The items of pediatric calculations in each mode are as follows:
2D/3D Mode Hip Joint
M Mode: not yet specified
Doppler Mode: not yet specified
11.2.9.2 Before starting Pediatric Calculations
1. Press the [Patient] key on the control panel, select the [PED] page and enter all patient
information for Pediatric calculations. For details refer to: Entering Patient Data
(chapter
'Entering Patient Data'
on page 4-10
)
Note
To cancel all calculations performed before and to start new measurement, press this key and
select [End Exam] or [Clear Exam].
2. Press [Start Exam].
3. Make sure that the probe and application are selected properly. If another application is
selected, press the [Probe]
key on the control panel, and change it to Pediatrics. For details
refer to:
Probe/Program Selection
(chapter
'Probe/Program Selection'
on page 4-7
)
11.2.9.3 Pediatric Calculations in 2D Mode
•
Hip Joint
(chapter
'Hip Joint'
on page 11-92
)
Measurements and Patient Worksheets (Reports)
Voluson® S6/S8 Basic User Manual
5433669-100 Revision 4 11-91
To Next Page
