If a Fetus number has been entered, several fetuses can be measured on one patient.
Select this flipswitch to change from fetus A to B or C or fetus D.
2. Press the [GA] key on the menu area to enter the Gestational Age. Alternatively the GA can
be calculated by entering the LMP the DOC or the EDD. For details refer to: Entering Patient
Data
(chapter
'“Patient Information” screen'
on page 4-13
)
3. Make sure that the probe and application are selected properly. If another application is
selected, press the [Probe]
key on the control panel, and change it to Obstetric. For details
refer to:
Probe/Program Selection
(chapter
'Probe/Program Selection'
on page 4-7
)
11.2.4.16 Obstetric Calculations in 2D Mode
•
Distance Measurements
(chapter
'Distance Measurements'
on page 11-50
)
(like Aortic
valve, Ascending Aorta, etc.)
•
Area Measurements (see, '2D Mode Measurements'
on page 11-5
) (like RV Area, LV
Area)
Measurements and Patient Worksheets (Reports)
Voluson® S6/S8 Basic User Manual
5433669-100 Revision 4 11-49
To Next Page
