The “3D/4D Settings” menu appears on the monitor.
2. Select a program button and press [Set] (labelling area and cursor are displayed inside).
3. Enter a new program label using keyboard or overwrite the existing label or don’t change an
existing program label, if the same term is desired.
4. Select [Save] or [Save&Exit]. The program parameters are saved in the database.
Exit: Back to the last active menu without saving.
Delete: To delete stored settings from the database.
Save: To save settings with the active Settings select menu.
Return: Back to the User Setting main menu.
Default: A change of the default setting is protected by a password. The User cannot change
the label “Default”.
13.2.3.2.4 To Enter/Overwrite Text Auto
1. Select the [Text auto] button (in the System Setup – User Settings page).
Utilities and System Setup
13-22
Voluson® S6/S8 Basic User Manual
5433669-100 Revision 4
To Next Page
