iPECS UCP
Feature Description and Operation Manual Issue 1.3
170
2.55 LNR (Last Number Redial)
Description
The last number dialed is stored (up to 48 digits) in the Station’s Last Number Redial buffer.
You may request the system redial the last dialed number without the need to dial the
number.
For iPECS IP and LDP Phones with displays, the last 10 numbers are stored in the LNR
buffer. The user may view the ten numbers using the [VOL UP]/[VOL DOWN] button to scroll
and select the number to dial from the list.
Operation
LDP Phone
1. Lift the handset or press the [SPEAKER] button.
To use Last Number Redial using the [Redial] button
2. Press the [REDIAL] button.
3. Press the [VOL UP]/[VOL DOWN] button to highlight the desired number.
4. Press the [HOLD/SAVE] or [REDIAL] button to dial the number highlighted.
iPECS IP Phone
[TRANS/PGM] + {FLEX} + [TRANS/PGM] + “97” + [HOLD/SAVE]
To assign a {Redial} button
1. Press the [DIR] Soft button.
To use Last Number Redial using the LIP-8000/8000E/9000 series phone w/3-soft buttons
2. Press the [SPEED] Soft button.
3. Dial “*”.
4. Use the Navigation button to select the desired number.
5. Press the [HOLD/SAVE] button to place the call.
Or,
1. Press the {REDAIL} button.
2. Use [VOL UP]/[VOL DOWN] to scroll or {REDAIL} to dial the highlighted number.
SLT
1. Lift the handset.
To use Last Number Redial
2. Dial “552”, the Last Number Redial code.
Conditions
1. For iPECS IP and LDP Phones with display, the redial buffer will store duplicate
numbers unless dialed consecutively.
2. When the outside Line used for the original call is busy, the system will select an
To Next Page
Loading...
