iPECS UCP - 5.18 Ring Tone Selection and Download

iPECS UCP
Feature Description and Operation Manual Issue 1.3
358
5.18 Ring Tone Selection and Download
Description
You can select one of Ring tones so that the iPECS IP Phone ring can be distinguished from
other nearby phones. Eight tones are stored in the iPECS IP Phone permanent memory. The
first four tones are fixed and the 5th through 8th Ring tone can be downloaded from a library
of 10 tones stored in the system’s protected memory. After downloading the tone from the
system memory, it can be selected as the Differential Ring Tone.
If using an LDP Phone, you can select one of 15 Ring tones stored in the phone.
Operation
iPECS IP Phone
1. Press the [TRANS/PGM] button.
To download a Ring Tone from the system memory
2. Dial “15”, Ring Tone Download code.
3. Dial the desired Ring tone location, “5”~“8”.
4. Dial digits “00” through “10” to hear the Ring Tones.
5. Press the [HOLD/SAVE] button.
1. Press the [TRANS/PGM] button.
To select a Ring Tone
2. Dial “11” for Intercom Ring tones, “12” for Line Ring tones.
3. Dial the digit (“1”~“8”) to select the Ring Tone.
4. Press the [HOLD/SAVE] button.
LDP Phone
1. Press the [TRANS/PGM] button.
To select a Ring Tone
2. Dial “11” for Intercom Ring tones, “12” for Line Ring tones.
3. Dial the digit (“1”~“15”) to select the Ring Tone.
4. Press the [HOLD/SAVE] button.
Conditions
1. The downloadable ring tone files are stored in system memory as *.wav files with a
maximum length of 4 seconds.
Programming
Related Features
 Station User Programming & Codes
 Differential Ring
Hardware
 iPECS IP or LDP Phone