iPECS UCP - 2.59 Multiple Voice Mailbox Support

iPECS UCP
Feature Description and Operation Manual Issue 1.3
179
2.59 Multiple Voice Mailbox Support
Description
A station can access any Voice Mailbox by dialing the VM group, the mailbox number and
password. If you use an iPECS IP and LDP Phone, one or more Flex buttons of your phone
can be configured to access a specific mailbox and receive a visual indication (LED flashes)
of message status in the mailbox. A Flex{VMAILBOX} button is assigned to allow access to
each Voice Mailbox.
Operation
iPECS IP & LDP Phones
[TRANS/PGM] + {FLEX} + VM group + Mail-box (station) number + [HOLD/SAVE]
To assign a {VMAILBOX} Flex button
1. Lift the handset or press the [SPEAKER].
To access a Voice Mailbox using the {VMAILBOX} Flex button
2. Press the {VMAILBOX} Flex button.
3. Dial the Mailbox password.
Conditions
1. A Flex button can be assigned to access the Mailbox for a Station Group or
outside Line Voice Mailbox.
2. The {VMAILBOX} button LED will flash indicating new messages have been
received in the associated mailbox.
3. A Flex button cannot be assigned to access the mailbox of a networked station.
4. An external Voice Mail system may not provide proper notification to the system of
message status and thus, the {VMAILBOX} button LED may not properly indicate
new messages when using an external Voice Mail system.
Programming
Related Features
 External Auto Attendant/Voice Mail
 Integrated Voice Mail
Hardware
 iPECS IP or LDP Phone
 External or Integrated Voice Mail