iPECS UCP - 2.80.2.8 Net Call Forward

iPECS UCP
Feature Description and Operation Manual Issue 1.3
241
Programming
NETWORKING DATA Net Basic Attributes
Net CO Line Attributes
Net Numbering Plan
Related Features
 Station Message Wait/Call Back
 Do Not Disturb (DND)
Hardware
2.80.2.8 Net Call Forward
Description
A user can forward (send) their calls to another station, Station Group or a user’s VMIB
mailbox across the private network. The user may forward all calls immediately, if the user
does not answer the call or if the station is busy. In addition, the user may select to activate
‘Follow-me’ forward, forwarding calls from a location other than the station. Calls forward in
the same manner as a Call Forward within a system and is transparent to the user.
From a network perspective, the iPECS UCP can use either the ‘Join’ or ‘Re-route’ signaling
method to complete a call forward over the network. The Networking Transfer Mode assigns
the method that will be used and should be selected to match other systems connected in the
private network.
 Join - an additional connecting path is needed to transfer the call to another station.
 Routing - a new connecting path is used to forward the call.
You select the type and condition under which calls will forward by entering a Call Forward
code as follows:
Code 0: Remote Call Forward, forwards all calls to the station, except recalls, activated
from a remote station, Call Forward, Follow-me.
Code 1: Unconditional, all calls to the station, except recalls, forward internally or
externally immediately upon receipt.
Code 2: Busy, if the station is busy, forwards all calls, except recalls, to the selected
station.
Code 3: No Answer, forwards all calls, except recalls, to the selected station when the
station does not answer within the No Answer timer.
Code 4: Busy/No Answer, forwards calls if the selected station is busy or does not
answer within the No Answer timer.