iPECS UCP
Feature Description and Operation Manual Issue 1.3
301
4.3 CO Line Flash
Description
Analog CO Lines recognize a brief open or ground connection, “Flash”, as a request for new
dial tone. When used behind a PBX, a Flash is often used to activate a PBX feature or call
transfer.
Operation
iPECS IP & LDP Phones
[TRANS/PGM] + {FLEX} + [TRANS/PGM] + “94” + [HOLD/SAVE]
To assign a Flash Flex button
1. Press the {FLASH}button; the system generates a flash on the analog CO line.
While connected to an analog CO line
SLT
1. Momentarily depress the Hook-switch.
While connected to an analog CO line
2. Dial “551”, the Flash feature code, the system generates a Flash on the analog CO
Line.
Conditions
1. Stations may Flash on an analog CO Line defined for PBX operation and will
experience COS (Class of Service) dialing restrictions after a PBX Trunk access
code is dialed.
2. During a Flash, the LED for the Line button will remain lit.
3. A Flash may be stored as a part of a Station or System Speed Dial number.
4. While connected to an internal call or dial tone, activating Flash will return internal
dial tone.
5. While making a Page Announcement, activating Flash will terminate the Page
Announcement and return internal dial tone.
6. The Flash function is not available on ISDN and IP Line calls.
Programming
To Next Page
Loading...
