iPECS UCP
Feature Description and Operation Manual Issue 1.3
356
5.17 Prime Line Immediate/Delayed
Description
When you go to an off-hook state, the system normally provides ICM dial tone. If desired, a
station can be assigned to access a different pre-assigned system resource (Prime Line).
The Prime Line can be any of the Idle Line Settings:
Seize an outside Line
Call another station
Activate a Flex button feature
Call to pre-assigned Hunt group
Call to pre-assigned Station Speed
Call to pre-assigned System Speed
Prime Line access can be defined as immediate or delayed. When assigned immediate, upon
an off-hook event, the system provides access to the Prime Line. With Delayed Prime Line,
you receive normal Intercom dial tone for the Prime Line Delay timer and, after the delay, the
Prime Line is accessed. This allows you to make a selection overriding the Prime Line.
Operation
iPECS IP & LDP Phones
1. Lift the handset or press [SPEAKER] button and take no action, Prime Line as
assigned will be accessed.
To access the station’s Prime Line
Conditions
1. Any of the station’s Flex buttons may be assigned as the Prime Line. When you lift
the handset or press the [SPEAKER] button, the system will act as if you pre-
selected the button prior to going off-hook.
2. Selection of another Flex button or Feature button just prior to an off-hook event
will override the Prime Line assignment.
3. A SLT can be assigned an Idle Line Selection with a Speed Bin Number.
4. When Delayed Prime Line is set, you must wait, taking no action until the Prime
Line is accessed. You will receive ICM dial tone during this period and may dial
any valid numbering plan digit(s), select a Flex button, or feature button.
5. If the Prime Line Delay Timer is greater than the Dial tone time-out, the Delayed
Prime Line will not activate. It will be necessary to reduce the delay timer or extend
the Dial tone time-out.
Programming
STATION DATA Common Attributes Prime Line
To Next Page
Loading...
