iPECS UCP - System Clock Set

iPECS UCP
Feature Description and Operation Manual Issue 1.3
405
6.19 System Clock Set
Description
The System Attendant can set the system Time/Date.
Operation
System Attendant
1. Press the [TRANS/PGM] button.
To set the system clock
2. Dial “041”, the Attendant Station Program code.
3. Dial six (6) digits for the Date (MM/DD/YY) or [HOLD/SAVE] to skip the Date.
4. Dial four (4) digits for the Time (HH/MM) or [HOLD/SAVE] to skip the Time setup.
5. Press the [HOLD/SAVE] button, confirmation tone is heard and the Attendant
station returns to idle status.
1. Press the [TRANS/PGM] button.
To synchronize the system clock to the ISDN
2. Dial “046”, the Attendant Station Program code.
3. Dial “1” to synchronize the Date and Time to the ISDN.
4. Press the [HOLD/SAVE] button, confirmation tone is heard and Attendant station
returns to idle status.
Conditions
1. The time is entered in the24-hour format.
2. If an NTP (Network Time Protocol)server is assigned, the system will check the
time every ten (10) minutes. If the system time is more than 10 seconds off, the
system time is synchronized with the NTP server. This will override the Attendant
setting.
Programming
SYSTEM DATA System Attributes Network Time & Date
Attendant Assignment
System Date &Time
Related Features
 LCR (Least Cost Routing)
 SMDR (Station Message Detail Recording)
 Auto Service Mode Control
 Automatic System Time Synchronization
 Automatic System Daylight Savings Time
 Day/Night/Timed/Scenario Ring Mode
Hardware
 iPECS IP or LDP Multi-button Phone, a 24-button phone is
recommended