iPECS UCP
Feature Description and Operation Manual Issue 1.3
80
2.25 Delayed Line Ring
Description
Ring signals for an incoming call on a “Normal” type outside Line can be sent to Stations
immediately upon detection or after an assigned ring cycle delay. The delay can be up to nine
(9) system ring cycles, thus allowing other Stations to answer the call. Note a “Normal Line is
a standard non-DID/DISA line which uses “Ring Assignment ”to determine the Station(s) to
receive the call.
Operation
System
Conditions
Delay Ring operation is automatic when assigned.
1. Outside Lines must be assigned an immediate ring destination. As a default all
incoming outside calls ring to the Attendant Station 1000 and, if no immediate
destination is assigned, the Attendant will receive ring for the call.
2. Delay Ring can be assigned for a Station or Station Group.
3. If zero delay is entered when programming Ring assignments, the Station will
receive immediate ring. If no delay is entered, the Ring assignment for the station
is deleted.
4. Private Lines may be assigned with delayed ring.
Programming
To Next Page
Loading...
