iPECS UCP
Feature Description and Operation Manual Issue 1.3
235
based on the station number dialed and the Network Numbering Plan.
3. If you press the [TRANS/PGM]or other buttons during a transfer, the transfer is
cancelled. The original call is re-established if the [TRANS/PGM] button or original
CO Line button is pressed.
4. Network Call Transfer will recall to the transferring station if no response is
received from the called system in the Net Transfer Recall Time.
5. Networked systems are not designed to be non-blocking. Should no path be
available to complete the transfer, error tone is provided to the caller.
6. If the receiving station is busy, the transferring user will receive busy tone and may
camp the call to the busy station. If the receiving station is in DND, the call is
rejected, the caller receives fast-busy tone and cannot camp-on.
7. If a network failure occurs, the system will place an outside call using the Alternate
Speed Dial bin assigned in the Network Numbering Plan that corresponds to the
called user. Note this is not a Distributed Network call and thus features associated
with Networking such as Call Back, are not available.
8. The LCD will display the caller’s Name if Calling Name Identification Presentation
(CNIP) is enabled in the Networking parameters and the caller’s Name is assigned
in their local iPECS system.
Programming
NETWORKING DATA Net Basic Attributes
Net Supplementary AttributesNet Transfer Mode, Net
Trans Recall timer
Net CO Line Attributes
Related Features
Call Transfer, Station
Speed Dial
Hardware
2.80.2.3 Net Call Identification Service
Description
When Calling Name Identification Presentation (CNIP) and Connected Name Identification
Presentation (CONP) are enabled, the station name is provided as the caller identification
received and displayed at a station receiving a call from a Networked station.
Operation
Operation of the Station Name Display is automatic when configured.
To Next Page
Loading...
